دليل اختيار الغاطس

Submersible pump: clean water, sewage and macerator, or artesian wells. Which submersible pump do you need?

, by عامر شوب, 6 min reading time

A settlement tank that overflows, a soak pit that floods, or a deep artesian well? A simple guide to choosing the right submersible pump, with a table of all available pumps.

Is the yard flooded after the winter rains? Is the septic tank overflowing? Is the well deep and the above-ground pump can't reach it? This is where the submersible pump comes in: It's a pump that goes down into the water itself, so the depth below it doesn't matter, and it pushes the water up instead of pulling it. But beware: Putting a clean water submersible pump in the sewage will quickly ruin it.

In short: Clean water (tank, yard, pool)? Clean water submersible. Sewage with small solids? Sewage submersible. Septic tanks with solid waste? Submersible with grinder. Narrow and deep artesian well? 4-inch well submersible.
Type Water Best for
Clean water submersible Clean or semi-clean Draining yards, tanks, and pools, lifting to a tank
Sewage submersible Dirty water with small solids Sewage and inspection chambers
Grinder submersible Sewage with solid waste Septic tanks, grinds before pumping
4-inch well submersible Clean water from a well Deep artesian wells

💧 Clean Water Submersible

For flooded yards, emptying tanks for cleaning, and lifting water from a collection well. Models with a float operate automatically when the water reaches a certain level and turn off when it's done.

🚽 Sewage and Grinder Submersible

Its opening is wider and the impeller is designed to pass solid materials. The grinder has blades that cut waste before it enters, so it doesn't clog the pump or the pipe. This is the solution for septic tanks instead of a leach field every month.

❌ Common mistake: Using a clean water submersible to drain a septic tank. The impeller clogs and the motor overheats and burns out. For sewage, you need a sewage or grinder submersible.

🕳️ 4-inch Artesian Well Submersible

Long and narrow to fit into the well pipe (4 inches), and has many stages stacked on top of each other that lift water from great depths. The HP is determined by the water depth in the well + the tank height. We explained the method in detail in the [Well Submersible Guide].

💡 Do not run the submersible outside of water even for a minute. Water is what cools the motor. And hang it with a rope or chain, not the cable.

📋 All Submersibles Available to Us

Submersible HP Type
Total TWP63706 0.5 Clean water
Dailo DTWPQA012 0.5 Clean water
Dinky 550 Watt 0.75 Clean water
Dinky 104075 750 Watt 1 Clean water
Vido WD020550750 1 Clean water
Vido WD020580750 1 Plastic
APT QDX1.5-32 1 Clean water, 34m
Dailo DTWPWA03 1 Stainless
Vido WD020511100 1.5 Clean water
Henz QDP-750A — Plastic, 10m
Dailo DTWPQDC12 — 12V
2-inch Submersible — —
Habco without Grinder Sizes —
APT GV750 1 Sewage, 13m
Total TWP775016 — Stainless Sewage
Vido WD020521100 1.5 Grinder
Vido WD020531500 2 Grinder
Habco — Sewage Grinder
Submersible with Grinder — Grinder
Vido WD020620750 1 4-inch Wells
Dinky 104210 1 Stainless Artesian
Vido WD020621100 1.5 4-inch Wells
Vido WD020621500 2 4-inch Wells
Vido WD020622250 3 4-inch Wells
Aydun KMP65L 3 Wells

Frequently Asked Questions

Does the submersible operate automatically?

If it has a float: Yes, it operates when the water rises and turns off when it drops. Without a float, you must turn it on and off by hand or with a control panel.

How many meters does the submersible lift?

Depending on the model, it is written as "height" or "lift" in the specifications. The higher the lift, the lower the quantity.

Does the well submersible need a panel?

Many of them need an operating box or control panel, especially the large HP ones. Ask us before you buy.

Read More

Take a picture of the well or pit and send it to us on WhatsApp and we will tell you the right submersible.

Tags


Blog posts